SwiftWing PDB02-XT60 – 3S–6S Power Distribution Board with XT60 Connector

The SwiftWing PDB02-XT60 is a high-current 3S–6S Power Distribution Board with XT60 Connector, designed for multirotor and UAV systems that require clean and organized battery integration without onboard voltage regulation.

Unlike regulated PDB variants, this board provides a direct battery bus while including a factory-installed XT60 connector for simplified installation. If your build requires onboard voltage regulation, consider the 3S–6S 120A Power Distribution Board with 5V & 12V BEC, which integrates dual switching regulators for flight electronics and FPV systems.

---

High-Current ESC Distribution

This 3S–6S Power Distribution Board with XT60 Connector is built on a 4-layer 2oz copper PCB to ensure low voltage drop and stable high-current routing.

The PCB supports high ESC distribution capability, while actual system current may be limited by:

• XT60 connector rating (~60A typical)

• Wire gauge selection

• Cooling conditions

• Load balance across ESC outputs

For higher current builds requiring direct soldering, see our 3S–6S Direct Power Distribution Board.

---

Factory-Installed XT60 Battery Input

The integrated XT60 connector:

• Reduces installation time

• Provides standardized battery interface

• Maintains secure mechanical connection

Direct wire soldering is also supported at the battery pads if required.

---

Flexible ESC Output Pads

ESC outputs are provided as solder pads, allowing:

• Custom wire length selection

• Flexible ESC routing

• Balanced high-current layout

For a fully connectorized solution, see the 3S–6S Power Distribution Board with XT60 & 6 XT30 Connectors.

---

Designed for UAV Applications

This board is ideal for:

• Racing quadcopters

• Freestyle builds

• Long-range UAV platforms

• Robotics battery distribution

• Industrial drone systems

---

Technical Specifications

• Input Voltage: 3S–6S LiPo (11.1–25.2 V)

• Battery Connector: XT60 (factory-installed)

• Distribution Type: Direct battery bus

• PCB Construction: 4-layer, 2oz copper

• Board Size: 50 mm × 50 mm

• Mounting Pattern: 45 mm M3

• Finish: ENIG

• Weight: 13 g

---

Why Choose the XT60 Version?

Compared to solder-pad-only PDBs, the PDB02-XT60 simplifies installation by eliminating battery soldering while maintaining robust power routing performance.

---

Frequently Asked Questions

Q: Does this board include voltage regulators?
No. This is a direct battery distribution board. An external BEC is required.

Q: Are ESC connectors included?
No. ESC outputs are provided as solder pads only.

Q: What is the maximum current?
Current capacity is limited by the XT60 connector (typically ~60 A continuous depending on wiring and cooling).

Q: What battery voltage is supported?
This board is optimized and validated for 3S–6S LiPo systems.

---

What’s in the Box

• 1 × SwiftWing PDB-02-XT60

(No additional connectors, wires, or mounting hardware included)

Documentation

SwiftWing PDB-02-XT60 Datasheet (PDF)